MIMAKI JV300-130 - 3 Workflow; 3.1 Ink Related Parts

© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.2
R.1.2
1
2
3
4
5
6
7
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
JV300
Issue
2014.04.11
Revised 2014.06.19 F/W ver.
1.00
Remark
1.2
Rev.
7.1 Performing the Initial Ink Fill
 Working procedure 1 (Ink set selection)
1. Dip the clean stick into the washing solution, and moisten the
edges of cap.
2. Turn the power to the device on.
When the power is turned on, the firmware version is displayed.
 The machine can not recognize if the filling fluid cartridge has been set or removed. Be sure to check
the condition before performing each operation.
 Set a cartridge of the filling fluid or the ink according to the displayed.
Set the cartridges in the order correctly.
 Be sure to use a new cartridge or one with at least half the ink remaining.
LOCAL
Boot(logo)
MENU
TEST PRINT/
CLEANING
REMOTE
LOCAL
version
MENU
TEST PRINT/
CLEANING
REMOTE
LOCAL
MENU
TEST PRINT/
CLEANING
REMOTE
 Ensure the front cover is closed.