© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.3
7.1 Performing the Initial Ink Fill
R.1.1
1
2
3
4
5
6
7
3. Select the ink type.
AQUA: Aqueous ink (sb53, etc.)
SOLVENT: Solvent ink (SS21, etc.)
4. Press the [ENTER] key.
5. Select the ink set.
6. Press the [ENTER] key.
Working procedure 2 (Filling fluid discharging)
7. Remove the cartridge.
8. Press [ENTER], and discharge the filling fluid within the ink
route.
9. Press the [ENTER] key.
Select INK SET
○
AQUA
○
SOLVENT
MENU
TEST PRINT/
CLEANING
REMOTE
Select INK SET
○
4 color
○
6+W color
○
8color
MENU
TEST PRINT/
CLEANING
REMOTE
Ink set can be select at installation or at performing head cleaning (the user cannot replace it).
When you change the ink set, change the joint of the ink path. (5.1 (p.2))
Discharge SHIPPING LIQID
Remove Cartridges
Discharge SHIPPING LIQID
Start
Discharge SHIPPING LIQID
Discharging
Please Waint…
Be sure to confirm that no cartridge has been set.
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
JV300
Issue
2014.04.11
Revised
2014.05.08
F/W ver.
1.00
Remark
1.1
To Next Page
Loading...
