© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.4
7.1 Performing the Initial Ink Fill
R.1.2
1
2
3
4
5
6
7
Working procedure 3 (Filling fluid filling)
10. Set the filling fluid cartridge, and press [ENTER].
11. Press [ENTER], and start the filling of filling fluid.
12. Remove the filling fluid cartridge, and then press [ENTER].
13. Press [ENTER], and start the discharging of filling fluid.
Only implement “Fill up FILLING LIQUID” when you selected “SOLVENT” for the ink type.
If you selected “AQUA”, proceed to step 14.
Fill up FILLING LIQUID
Set cartridges
Fill up FILLING LIQUID
Start
Fill up FILLING LIQUID
Filling up
Please Waint…
Discharge FILLING LIQUID
Remove Cartridges
Discharge FILLING LIQUID
Start
Discharge FILLING LIQUID
Discharging
Please Waint…
The next operation is not started automatically
even when the filling fluid cartridge is set.
Carry out the next operation after confirming that
the cartridge has been surely set.
The next operation is not started automatically
even when the filling fluid cartridge is removed.
Carry out the next operation after confirming that
the cartridge has been surely removed.
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
JV300
Issue
2014.04.11
Revised
2014.06.19
F/W ver.
1.00
Remark
1.2
To Next Page
Loading...
