MIMAKI JV300-130 - Adjustments When Using Sublimation Transfer Ink

© 2014 MIMAKI ENGINEERING CO.,LTD. 5.2 P.8
R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
Rev.
5.2 Adjustments When Using Sublimation Transfer Ink
When using sublimation transfer ink (water ink), perform the following adjustments to avoid media cockling.
Adjustment of the Station Height
 Work procedures
1. Loosen the screw of cover fulcrum pin BKT which is at the
left side of front panel cover M.
2. Shift the cover fulcrum pin BKT to right, and remove the front
panel cover M.
3. Remove the front cover.
4. Move the head over the platen.
Front panel cover M
Screw of Cover fulcrum pin BKT
Cover fulcrum pin BKT
Front cover