MIMAKI JV300-130 - 2 Electrical Parts; 2.1 Block Diagram

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.6 P.16
R.1.1
1
2
3
4
5
6
7
INSTALLATION GUIDE > Printer Assembly > Check and cleaning the LM guide
Model
JV300
Issue
2014.04.11
Revised 2014.05.08 F/W ver.
1.00
Remark
1.1
Rev.
4.6 Check and cleaning the LM guide
 Work procedures
1. Using manual operation, move the carriage back and forth
along its full travel distance several times.
2. Visually check the LM guide left/right ends and the LM guide
block unit for formation of grease droplets, and wipe away any
grease droplets.
LM guide
Carriage
 The grease is applied for the purposes of
corrosion prevention and lubrication, so do not
remove any more than necessary, and do not use
alcohol or similar.