MIMAKI ML Tiger-1800B MKII - PLC Error List: Heater, Carriage, and Washing Errors; Specific PLC Error Codes and Solutions

60
Error
No.
Error
level
Error displayed Cause Measures
F445
1
Current heater
MIN
Belt heater current
error
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F446
2
Current heater
MAX
Belt heater current
error
F452
3
Belt generic
Fault
Belt control error
F453
3
Carriage
generic Fault
Carriage control error
F454
3
Carriage
thermoswitch
Alarm
Linear motor error
F456
3
Emergency ON
Emergency switch or
area sensor error
1. Check the following items.
1.1 Are all 4 emergency switches on the
machine released?
1.2 Are the machine covers (6 places)
completely closed?
1.3 Whether the maintenance cover is
completely closed.
1.4 Whether there is something shading
the area sensor.
2. Press the emergency reset switch.
3. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
4. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
5. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F457
3
Carriage sensor
UP position
Alarm
Carriage height
sensor error
1. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F458
3
Carriage Up
Motor Alarm
Carriage up/down
motor error
F459
3
Carriage Down
Motor Alarm
Carriage Down Motor
error
F460
3
Carriage
Homing sensor
Alarm
Carriage height
sensor error
F461
3
Motors Thermic
Alarm
Motor or power
breaker error
F462
3
Washing device
in maintenance
position (FC
S27.1)
Washing unit error
1. Insert and remove the washing unit, tap the
[DETAIL] button in the MPC [SYSTEM
ALARM] column, and then tap the [CLEAR
ALARM] button to check whether the error
can be reset.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.