MIMAKI ML Tiger-1800B MKII - PLC Error List: Cleaning, Air Pressure, and Door Errors; Specific PLC Error Codes and Solutions

61
Error
No.
Error
level
Error displayed Cause Measures
F463
3
Cleaning Station
sensors Alarm
Cleaning station
sensor error
1. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F464
3
Cleaning Station
Forward motor
Alarm
Cleaning station
motor error
F465
3
Cleaning Station
Backwards
motor Alarm
Cleaning station
motor error
F466
0 or
1 or
2
Cleaning
Solution LOW
level Alarm
Error of the remaining
amount of cleaning
solution
1. Check the remaining amount of cleaning
solution.
2. Add the cleaning solution if necessary.
3. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
4. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
5. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F467
2
Muting - Printing
AREA doors
The cover sensor
detection exclusion
key is on.
1. Turn Off the “EXCLUSION SAFETY
DOOR” key on the right front side of the
machine.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F468
2
Compressed Air
LOW pressure
Alarm
Air pressure error
1. Check the air pressure supplied to the
machine.
Required pressure
： 6 to 8bar
2. After checking, tap the [DETAIL] button in
[SYSTEM ALARM] of MPC, and tap the
[CLEAR ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.