MIMAKI ML Tiger-1800B MKII - Other Error List: Sensor Errors; Specific Other Error Codes and Solutions

70
Error
No.
Error
level
Error displayed Cause Measures
Sensor
5 09 2
0509:YY(________)HDC
POSCNT
HDC position counter
error occurred.
An error occurred in
the linear scale or Y
motor.
Turn off the power of the
internal PC and then the
main power of the machine
in this order, and then turn
on again after a while.
If it appears again, contact
your dealer, our sales office,
or call center.
5 19 2
0519:09(________)NEGATIVE
PRESS SENSOR
Negative pressure
sensor error
5 1A 2
051A:09(________)POSITIVE
PRESS SENSOR
Positive pressure
sensor error
5 31 2
0531:09(ZZZZZZZZ)INKTANK
SENSOR
ZZZZZZZZ indicates a path
number.
1: Path 1
2: Path 2
:
8: Path 8
Error in the balance of
the ink supply unit
Make sure that the ink tank
is set correctly, that there is
no impact, and that there is
no load on it.
Turn off the power of the
internal PC and then the
main power of the machine
in this order, and then turn
on again after a while.
If the problem persists
even after performing the
above operations, contact
your dealer, our sales
office, or call center.
5 4A 2
054A:YY(________)PDC
POSINT:1234
PDC position interrupt
does not occur.
An error occurred in
the linear scale or Y
motor.
Turn off the power of the
internal PC and then the
main power of the machine
in this order, and then turn
on again after a while.
If i
t appears again, contact
your dealer, our sales office,
or call center.