5-17
Chapter 5 Troubleshooting
1
2
2
2
5
SYSTEM HALT
ERROR 716
InkHeater Tmp :1234
The ink heater is too hot.
• Turn off the main power, and wait an hour
or more before turning it back on.
If control became impossible after the
error was displayed, the following mes-
sage is displayed.
Press [ ] and start ink heater control.
If the same error message appears, con-
tact our service desk or your local distrib-
utor to call for service.
ERROR 717
InkHeater Brk:1234
The ink heater is disconnected.
• Turn off the power button to the machine
and turn it on after a while.
If the same error message appears, con-
tact our service desk or your local distrib-
utor to call for service.
ERROR 718
InkHeaterPCB Thr :1234
The thermistor on the ink heater relay
board is defective.
ERROR 719
InkHeaterPCB Fuse :1234
The fuse on the ink heater relay board was
blown.
ERROR 71a
UV-DRV Fuse :0**0**
The fuse on the UV-DRV board was blown.
Message Solution
SYSTEM HALT (*)
000 :MESSAGE
Turn off the main power to the machine and turn it on after a while.
If the same error message appears, contact our service desk or your local distributor to
call for service.
(“000” is the error No.)
Message Cause Solution
I NK HEATER CONTROL
CANCEL < > START
To Next Page
Loading...
