MIMAKI SIJ-320UV - Washing the Ink Discharge Passage

4-9
4
2
Washing the Ink Discharge Passage
Wash the ink discharge passage on a regular basis (once
every 2 - 3 months) to prevent ink coagulation from
clogging the passage.
1
Press the
(TEST PRINT/CLEANING)
,
and press the key in Local.
2
Press to select “Station”, and
press the key.
• The Station MENU appears.
3
Press to select “Pump Tube
Wash”, and press the key.
• Press the [ENTER] key in the Execution Check
screen, and the carriage moves over the platen.
• Dry suction operation is performed repeatedly
until the washing work is completed.
4
Open the right side maintenance cover.
(1) Rotate the screws under the right side
maintenance cover (for two positions) to the
left and remove them.
(2) Hold the bottom of the right side
maintenance cover and pull it to the front.
(3) While pulling the right side maintenance
cover downward, remove it.
• If the right side maintenance cover is hard to
remove, use the supplied screwdriver.
5
Suction the cleaning solution into a
syringe and squirt about three syringes
worth of solution into each cap.
6
Close the right side maintenance cover
and press the key.
• After running a dry suction for a certain period of
time?the screen returns to step2.
Carriage
Right side
maintenance cover
Screw