4-14
7
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill the cap with the cleaning solution just before
the solution overflows from the cap.
8
Close the right side maintenance cover
and press the key.
• Perform the capping operation and wait 1 minute.
• The display provides a countdown display.
• When the resting time has passed, the machine
absorbs the cleaning solution filled in the cap, and
performs cleaning. Then the machine returns to
the display in step 2.
Nozzle Recovery Function
Nozzle Recovery: When nozzles missing can not be
improved at specific points, other good nozzles can be
used as alternatives for printing.
Print the nozzle pattern
Used to print a pattern and to check and/or register
clogged nozzles.
1
Press the
(MENU)
in Local.
2
Press to select “Maintenance”,
and press the key.
• Maintenance MENU appears.
3
Press to select “Nozzle
Recovery”, and press the key.
4
Press the key.
5
Press to select desired head(s)
(H1-2/H3-4), and press the key.
6
Press the key twice.
• Printing of the nozzle pattern will start.
• Select “ENTRY” then “Move to select of the
Nozzle line (Step 5) without drawing a pattern”
• When nozzle missing is not cleared even after this
washing is carried out several times, contact the
distributor in your region or our service office.
Overhead view
H1-A H1-D H2-A H2-CH1-B H1-C H2-B H2-D
• Set a media of more than 210mm put horizontally.
If a media with narrow width is set, printing will
only be conducted to midway.
Nozzle pattern of Head 1 and 2
To Next Page
Loading...
