MIMAKI SIJ-320UV - Setting the Printing Check; Setting the Auto Nozzle Recoverry; Setting the Judgement Condition

3-19
3
2
2
Setting the Printing Check
Select ON when you want to conduct nozzle check at the
start of online printing.
1
Press the
(MENU)
in Local.
2
Press to select “Nozzle Check”,
and press the key.
3
Press to select “Printing Check”,
and press the key.
4
Press to select ON, and press the
key twice.
• The “Check Interval” setting screen appears.
• “Select OFF to not set nozzle check. Proceed to
Step 11.
5
Press to select “Setup”, and
press the key.
6
Press to select setting value, and
press the key.
• select the nozzle check interval from “Length” or
“FILE”.
Length : nozzle check is conducted when the
printed length reaches the set length.
FILE : nozzle check is conducted when the
number of printed files reaches the
set number.
7
Press to select “Interval”, and
press the key.
8
Press to select setting value, and
press the key.
• The set value will differ according to the setting
selected in Step 5.
Length : 0.1 to 100 m
FILE : 0 to 300 files
9
Press the key.
10
Press to select “Continuation
Print”, and press the key.
11
Press to select setting value, and
press the key.
Setting value : Stop/ Continue
12
Press to select cleaning type,
and press the key.
13
Press to select setting value, and
press the key.
Setting value: Soft/ Normal/ Hard
14
Press to select retry count, and
press the key.
Setting value:0 to 3
15
Press the key several times to
end the setting.
Setting the Auto Nozzle Recoverry
set this if you want to conduct automatic nozzle recovery
when nozzle missing is detected.
1
Press the
(MENU)
in Local.
2
Press to select “Nozzle Check”,
and press the key.
3
Press to select “Auto Nozzle
Recoverry”, and press the key.
4
Press to select ON/OFF, and
press the key.
5
Press the key several times to
end the setting.
Setting the Judgement Condition
Set the conditions for judging nozzle missing.
1
Press the
(MENU)
in Local.
2
Press to select “Nozzle Check”,
and press the key.
3
Press to select “Judgement
Condition”, and press the key.
4
Press to select color, and press
the key.
5
Press to set the number of
nozzles for judgment, and press the
key.
6
Press the key several times to
end the setting.