MIMAKI SIJ-320UV - Setting Leaf Media; Removing the Taken-Up Media

2-16
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover and raise the clamp
lever.
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
4
Push down the clamp lever and close the
front cover.
• Set the media straight.
5
Press the key.
6
Press the key to select "LEAF" .
• If the [Setting the Display of Media Detection] of
Machine Setup set in “AUTO”( P.3-15), the
machine automatically detects the media width.
7
Setting the Logical Seek.
(1) Press [][] to select the set value.
• Set value : Media/ Data/ Quality
(2) Press the [ENTER] key.
• P.2-9When [Media Remain] of the Machine Setup
is "ON" ( P.3-14), you are prompted to enter
the media remaining amount. ( P.2-9)
Removing the taken-up media
1
Release the lock of the taking-up tension
bar and lower the tension bar.
2
Open the cover on the left side of the
taking-up shaft and pull the taking-up shaft
forward.
3
Pull out so that the white plastic collar is
inserted into the slot on top of the leg.
4
Pull the edges of the media to unroll it.
Clamp lever
Front cover
Media Press