MIMAKI SIJ-320UV - Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height .......................... 2-4
Note for media setting ................................. 2-4
Setting a roll media ..................................... 2-5
Setting a narrow roll media ......................... 2-9
Setting two narrow roll media
(twin rolls) .................................................. 2-13
Setting leaf media ..................................... 2-16
Removing the taken-up media .................. 2-16
Changing the printing origin ...................... 2-17
Preparing for the Heaters ............................2-18
Changing the Temperature Settings for the
Heaters ...................................................... 2-18
Test Printing ................................................2-18
Test Printing ...............................................2-19
Head Cleaning ............................................2-19
About head cleaning ..................................2-19
Perform head cleaning depending on the test
printing result .............................................2-19
Setting of Media Correction .........................2-20
Setting of Media Correction ......................2-20
Correct the ink drop position for bidirectional
printing ........................................................2-21
Printing Data ...............................................2-22
Starting a Printing Operation .....................2-22
Stopping a Printing Operation ....................2-22
Deleting Received Data (Data Clear) ........2-22
Chapter 2
Basic Operations