2-8
18
Press to feed the media about 10 cm,
and then release the lock of the tension
bar.
19
Roll up the media.
(1) Set the taking-up direction switch to
“Forward”/ “Backward” according to the
taking-up method.
(2) Press [] , and rotate the roll shaft 2-3 times
to take up the media.
(3) Press the [ENTER] key.
20
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• Set the media press to the position of 3mm away
from the media.
• When using a thick media(0.6 to 1.0mm), remove
the media press from the media before printing.
21
Close the front cover.
22
Press the key to select "ROLL" .
• If the [Setting the Display of Media Detection] of
Machine Setup set in “AUTO”( P.3-15), the
machine automatically detects the media width.
If set in “MANUAL”, refer to P.2-9 “Detecting
media width when media detection method is
“MANUAL””.
• When the detection of media width is over, move
to the setting screen of logical seek.
23
Setting the Logical Seek.
(1) Press [][] to select the set value.
• Set value : Media/ Data/ Quality
(2) Press the [ENTER] key.
• When [Media Remain] of the machine setup is
"ON" ( P.3-14), you are prompted to enter the
media remaining amount. ( P.2-9)
• To take up the media with its print-side facing
inside:
Set the taking-up direction switch to “Backward”.
• To take up the media with its print-side facing
outside:
Set the taking-up direction switch to “Forward”.
• To stop taking-up:
Set the taking-up direction switch to neutral (OFF).
When using a take-up device, it is recommended
to set the media with its print-side facing inside.
• This machine allows a media to be set with its
print-side facing either inside or outside. Setting
the print-side facing inside reduces the variations
in tension caused by the changes in the media
diameter occurring when the media is taken up,
and thus secures stable take-up.
Backward
Taking-up with the print side facing to
the inside.
Forward
Taking-up with the print side facing to
the outside.
OFF
Not operated.
Taking-up
manual switch
Taking-up direction switch
• When you do not use the take-up device, feed the
media until the media reaches the floor, and then
print.
If you print with the media out of contact with the
floor, the media feed amount varies during
printing, causing poor printing quality.
To Next Page
Loading...
