MIMAKI SIJ-320UV - Extended Functions

This chapter
describes the operation procedures for using the machine more conveniently and each
setting procedure.
About Setup MENU........................................3-2
Setup MENU table ....................................... 3-3
Setting of Media Correction.......................... 3-4
If the Positions of Dots Shift... ...................... 3-5
Setting the Heater ........................................ 3-5
Setting of Logical Seek ................................ 3-6
Setting of Overprint ...................................... 3-6
Setting of Left and Right Margins................ 3-7
Setting of UV mode ...................................... 3-7
Setting of Refresh ........................................ 3-9
Setting of Vacuum Fan................................. 3-9
Setting of Print Speed .................................. 3-9
Setting of MAPS4....................................... 3-10
Setting Auto Cleaning ................................ 3-10
Setting Interval wiping ................................ 3-11
About Machine Setup MENU....................... 3-12
Machine Setup MENU table....................... 3-13
Setting a AUTO Power-off.......................... 3-13
Setting Feeding unit ................................... 3-13
Setting Take-up unit ................................... 3-13
Setting the Display of Media Remain ......... 3-14
Setting Time................................................3-14
Setting Unit (Temperature/ Length) ............3-14
Setting a Key Buzzer ..................................3-15
Setting the Display of Media Detection.......3-15
Setting the CONFIRM. FEED .....................3-15
Initializing the Settings................................3-16
About Nozzle Check MENU .........................3-17
Nozzle Check MENU table .........................3-17
Printing Check Flow....................................3-18
Printing Operations at “Nozzle Missing”
Judgment and Error Occurrence ................3-18
Setting the Printing Check ..........................3-19
Setting the Auto Nozzle Recoverry.............3-19
Setting the Judgement Condition................3-19
About Information MENU .............................3-20
Information MENU table .............................3-21
Displaying the Information ..........................3-21
Displaying the Information of this machine.3-22
Setting a Language ......................................3-22
Chapter 3
Extended Functions