MIMAKI SWJ-320 S4 - Checking Path Length(for Right and Left) of Feeding Surface

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.3.8 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Checking path length(for right and left) of feed-
Model SWJ-320S Issued 2013.03.08 Revised F/W ver 1.0 Remark
1.0
Rev.
4.3.8 Checking path length(for right and left) of feeding surface
 Outline
If media skew is thought to be caused by the difference of the path lengths, check them.
 Required part
JV5 option: A103240/OPT-J0274 Path Length Measuring Wire Set
 Checking procedure (front of machine)
1. Remove the pinch roller at the right edge and attach the wire tip
with the pinch roller shaft.
2. Pass wire as indicated.
Fold back the path and pull wire up over the platen.
Pinch roller
OPT-J0274
When you push the pinch roller from above, it comes
off.
Push
ピンチローラ
OPT-J0274
Roll shaft
Tension bar