MIMAKI SWJ-320 S4 - Charge Ink

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.22 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > CHARGE INK
Model SWJ-320S Issued 2012.12.14 Revised F/W ver 2.10 Remark
1.0
Rev.
4.2.22 CHARGE INK
 Outline
Check/ clear the charge ink amount information inside the main body and write it into the ink IC.
 Procedures to check charge ink amount inside main body
1. Select [#ADJUST]->[CHARGE INK].
2. Select [INFORMATION].
3. Press [ENTER] and check the information of each colors.
 Procedures to write charge ink information into ink IC
You can write the charge ink information inside the main body into the used ink IC.
Use this function in the following situation.
1)If replacing MAIN PCB is required due to USB breakage, as you cannot upload parameters, charge ink information
is discarded. Therefore, it is necessary to back up charge ink information.
2)When replacing ink, it is necessary to save charge ink information of old ink type into the IC chip.
1. Select [#ADJUST]->[CHARGE INK].
2. Select [INK IC BACKUP].
FUNCTION
#ADJUST [ENT]
#ADJUST
CHARGEINK [ENT]
CHARGEINK
INFORMATION [ENT]
COL:KCS100:1234cc
LIMIT:2012/09
 After writing into the ink IC has been completed, charge ink information inside the main body is
cleared.
 You can write the charge ink information inside the main body only into the ink IC used for SWJ-320S
series.
 If charge ink information of old ink type is registered in the main body, you cannot change the ink
type.
 Save the ink IC into which you wrote the charge ink amount together with the ink bottle.
FUNCTION
#ADJUST
#ADJUST
CHARGEINK [ENT]
CHARGEINK
INKICBACKUP [ENT]
SELECTCOLOR
:BLACK
SELECTCOLOR
:NONE