MIMAKI SWJ-320 S4 - Replacement of the 180 LPI Encoder Sensor

© 2013 MIMAKI ENGINEERING CO.,LTD. 3.3.6 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Workflow > Electrical Parts > Replacement of the 180 LPI Encoder Sensor
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.
3.3.6 Replacement of the 180 LPI Encoder Sensor
 List of replacement procedures
Item Work operation Description Ref.
Covers
1.

Power OFF Turning the main power OFF.
* Be sure to turn the main power OFF since the power
comes ON due to the sleep control if turned to OFF by
the power SW on the panel.
---
2. 
Removal of covers, etc. Remove the following covers.
 Carriage cover
 SD PCB cover
6.1.1
Encoder Sen-
sor
3.

Encoder Sensor replacement 6.4.4
Check/
Adjustment
4. 
Encoder position adjustment Checking the encoder mounting at the specified position. 4.3.6
5.

Power ON Turning the power ON to start the machine. ---
6. 
Encoder check Carry out the encoder check to confirm it functions nor-
mally.
5.1.9
Covers
7.

Mounting of the covers. Mount the covers that have been removed. 6.1.1
For the power OFF, be sure to turn the main power OFF.
If the sleep function works accidentally during the operation, it is very dangerous.
180 LPI Encoder Sensor