MIMAKI SWJ-320 S4 - Default Set

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.10 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > DEFAULT SET
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
4.2.10 DEFAULT SET
 Outline
Returning each parameter to the initial value.
 DEFAULT SET List of Items
 Work Procedures
1. Select [#ADJUST] -> [DEFAULT SET].
2. Select the parameter to be initialized, and then fix it by [ENTER].
[]/[]: Switch
[ENTER]: Confirms (to Confirmation display)
[END]: Return
3. Initialize by [ENTER].
[ENTER]: Execute
[END]: Return
No Item Operation Remarks
1 SYSTEM PARAMETER Initialize the parameter in question.
2 SHIPPING set Initializing parameters of others than the adjustments.
3 MAINTE PARAMETER Initialize the parameter in question.
4 SERVO PARAMETER Initialize the parameter in question.
5 FEED PARAMETER Initialize the parameter in question.
6 HEAD PARAMETER Initialize the parameter in question.
7 OPE PARAMETER Initialize the parameter in question.
8 INK PARAMETER 1 Initialize the parameter in question.
9 INK PARAMETER 2 Initialize the parameter in question.
10 DEBUG PARAM Initialize the parameter in question.
11 SCAN PARAMETER Initialize the parameter in question.
12 NOZLE RECOCVERY PARAM Initialize the parameter in question.
FUNCTION
#ADJUST [ENT]
#ADJUST
DEFAULT SET [ENT]
#DEFAULT SET
SYSTEM param. [ENT]
SHIPPING set
MAINTE PARAMETER
:
#DEFAULT SET
INITIAL. OK? :ent
Parameter initialized