MIMAKI SWJ-320 S4 - Power Does Not Turn On

© 2013 MIMAKI ENGINEERING CO.,LTD. 5.1.10 P.2
5.1.10 LINEAR ENCODER
R.1.1
1
2
3
4
5
6
7
8
 Error display
No. Error and LCD display Checking at error
1 Error in the encoder counting cycle.  Twisting of the linear encoder scale.
 Space between the encoder sensor and linear encoder scale.
 Contact of the encoder sensor with linear encoder scale.
 Presence of damage on the linear encoder scale.
 Check the slack of setscrew.
2 Error in linear encoder coordinates after com-
pletion of reciprocating movement.
 Checking for twisting of the linear encoder scale.
 Checking for a space between the encoder sensor and linear encoder scale.
 Checking for contact of the encoder sensor with linear encoder scale.
 Checking for the presence of damage on the linear encoder scale.
 Check the slack of setscrew.
3 The difference between the motor encoder
value and linear encoder value is large.
 If the motor encoder value is larger than the linear encoder value, loosen the
tension of linear encoder scale since it may be too strong.
 If the motor encoder value is less than the linear encoder value, strengthen the
tension of linear encoder scale since it may be too loose.
 Check the slack of setscrew.
ERROR:ENCCOUNT
SHORT:265LONG:500
POS1:300.0 (500)
POS1:0.0 (0)
Distance from Right
edge of Print home to
Position at error
ERROR:DIF(POS)
POSDIF:10 [cnt]
ERROR:DIF(MTR/ENC)
M/EDIF:‑0.30[%]
MAINTENANCE MANUAL > Test Items > Test Function > LINEAR ENCODER
Model SWJ-320S Issued 2012.07.19 Revised 2012.12.14 F/W ver 1.0 Remark
1.1
Rev.