MIMAKI SWJ-320 S4 - Ink Purge

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.14 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > INK PURGE
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
4.2.14 INK PURGE
 Function
Moving the carriage to maintenance position of the left of machine, and discharging the optional ink.
Also, [#Ink purge] is used for the ink discharging/charging when the parts around ink are replaced.
Discharging the ink between the ink bottle and the print head or between the liquid supply pump and the print head,
by turning the liquid supply pump to ON/OFF.
When the following parts are replaced, perform the work according the referenced procedure.
 Work Procedures
1. Select [#ADJUST] -> [INK PURGE].
2. Press [ENTER] key to move the carriage to the maintenance
position.
3. Select ON/OFF of the ink pump.
ON: The ink pump operates until the float sensor within the
ink tank turns ON.
OFF: The ink pump does not operate.
[]/[] :Liquid supply pump ON/OFF selection
[ENTER] : End
4. Check the ink color, and press the purge button.
5. Manually perform wiping.
6. Press [ENTER] key to end.
Part name Liquid supply pump Reference
Print head
OFF
Ink discharging at part replacement (Liquid supply pump OFF)
see p.2
Ink tank
OFF
Ink pump
ON
Ink discharging at part replacement ( Liquid supply pump ON)
see p.3
FUNCTION
#ADJUST [ENT]
#ADJUST
INKPURGE [ENT]
INKPURGE
CARRIAGEOUT [ENT]
INKPURGE (ON)
COMPLETED [ENT]
INKPURGE (O FF )
COMPLETED [ENT]
(Purge button enable)
Purge button
Lamp button
Open/close cover