MIMAKI SWJ-320 S4 - Maintaining the Capping Station

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.22 P.2
4.2.22 CHARGE INK
R.1.0
1
2
3
4
5
6
7
8
3. Select the color to rewrite the amount of charge ink with Press
[]/[]key.
4. Set the used ink IC
.
5. When you back up charge ink information inside the main body
into the ink IC, select “YES”.
6. When you select “YES”, writing into the ink IC starts.
7. Press [ENTER].
 Procedures to clear charge ink information inside main body
You can clear charge ink information inside the main body.
Use this function in the following situation.
1)Though you cannot write charge ink information inside the main body as there is no used ink IC, you want to clear
charge ink information of old ink type to replace ink.
1. Select [#ADJUST]->[CHARGE INK].
 If the charge ink information registered in the main
body is less than 1cc, you cannot write it into the
IC.
 If charge ink information of all colors are less than
1cc, “NONE” is displayed.
 Only one type color can be written into one ink IC.
When you write charge ink information of four
colors, prepare four ink ICs.
PLEASEINSERTINKIC
WRONGINKIC
CANNOTWRITE
UNUSEDINKIC
CANNOTWRITE
 You can write only into the ink IC usable for SWJ-
320S series.If you set the ink IC other than it, an
error message is displayed.
 You cannot write into an unused ink IC. Set the
used ink IC. If you set an unused ink IC, an error
message is displayed.
BACKUPOK?
NO<>YES
**WRITING**
DONOTREMOVEINKIC
COMPLETED
[ENT]
 Do not pull out the ink IC during writing.
 Do not turn off the power supply during writing.
 You cannot restore cleared charge ink information. Fully be careful to perform this function.
FUNCTION
#ADJUST[ENT]
#ADJUST
CHARGEINK [ENT]
MAINTENANCE MANUAL > Adjustment > Adjustment Items > CHARGE INK
Model SWJ-320S Issued 2012.12.14 Revised F/W ver 2.10 Remark
1.0
Rev.