MIMAKI SWJ-320 S4 - Page 70

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.8 P.2
4.2.8 PRINT ADJUST
R.1.1
1
2
3
4
5
6
7
8
 BiDir pattern
6. Select [BASIS SET 720std] and press the [ENTER] key. The
values adjusted in 720std are set as the correction values of
other modes.
7. Perform adjustments similar to 720Std in modes other than
720Std.
Figure when viewed
using a magnifying lens
Enter a correction value in the positive direction
Reference lines
Adjustment lines
Enter a correction value in the negative direction
Reference lines
Adjustment lines
#PRINTADJUST
:BASISSET720std
The values set using [BASIS SET] are values cal-
culated as a guideline for correction values. Thus,
the actual ink landing position may be mis-
aligned. Be sure to adjust the landing position for
each mode that will be used.
MAINTENANCE MANUAL > Adjustment > Adjustment Items > PRINT ADJUST
Model SWJ-320S Issued 2012.07.19 Revised 2013.02.15 F/W ver 1.0 Remark
1.1
Rev.