6 Image Acquisition
Operator’s Manual 6 - 69
Delete View
Tap [Prev]/[Next] to select the view to be deleted. Tap [Delete] to delete the selected view.
6.17.3 Manual Examination
Suspend - Exit the protocol so the user can run the system manually. This is used when an unusual
or atypical workflow is required.
• Start manual examination: tap [Suspend] to pause the current iWorks protocol. The system
enters manual examination status.
• Return to iWorks: tap [Resume iWorks] to return to automated status. You can continue the
previous iWorks scan.
6.17.4 Insert
Insert is a specialized protocol event within iWorks and iWorks OB. It assists with the workflow for
documenting and measuring common pathological (disease) states (i.e. Mass, Cyst, Stenosis,
Thrombus) that occurs outside a routine, normal examination.
Perform the following procedure:
1. Tap [Insert] on the touch screen to enter the status.
2. Select the necessary protocol and the system adds the protocol events to the current protocol.
3. Perform measurements or add comments/body marks to the image if necessary.
6.17.5 Create
The ultrasound system supports creating a user-defined iWorks protocol based on user’s habits.
1. Tap [Create] on the touch screen.
2. Press the knob under [Start] to start creating an iWorks protocol.
– During creating, the red button of REC on the touch screen is blinking.
– Press the knob under [New Group] to add more groups.
– Press the knob under [Pause] to pause the creating.
– Press the knob under [Continue] to continue the creating.
3. Press the knob under [Stop] to enter Protocol Setup and Review page.
– You can rename Groups, Views, or Protocols.
– Select type from the drop-down list as Sequence, Random, or Insert Protocol.
– Tap or click [Save] to temporarily save the creating.
4. Tap or click [Generate Protocol] to generate a user-defined iWorks protocol.
To Next Page
Loading...
