Mindray Resona R9 - Adjusting Monitor Position; Adjusting Height and Displacement

3 - 6 Operator’s Manual
3 System Preparation
• Press the power button to select [Standby]. The system enters standby status.
To Exit Standby
Press the power button.
TIP:
When the system enters the standby status, and you need to power off: Press the power button to
exit the standby status and then power off the system.
3.4 Adjusting Monitor Position
Gently hold the bottom edge of the monitor when adjusting its position.
3.4.1 Adjusting Height and Displacement
Move the monitor support arm up or down to adjust the height, back and forth to adjust the
displacement.
150mm
300mm