Z Axis Offset Calibration
Click the "Start" button to begin the
automatic calibration. Initially, the left
extruder will move to the top of the Z axis
calibration sensor and slowly descend to
trigger the switch. It will then automatically
switch to the right extruder, repeating the
same motion as the left extruder.
Click the "Z Offset" button.
After the automatic calibration is
complete, click the "Accept" button
to save the Z-axis offset value.
Tips: Wipe the nozzle clean before calibration to avoid any interference during the process.
14
Safety Reminder: To ensure that the nozzle correctly lands on the sensor, please calibrate the XY axis before
calibrating the Z axis. While the extruder is moving downward, pay close attention to its movement. If there is
excessive deviation or signs of extreme extrusion pressure, click the return button in the top left corner of the
screen or the emergency stop button in the bottom left corner to stop the calibration. Contact customer
support or refer to official videos for troubleshooting solutions.
To Next Page
Loading...
