Mingda MD-600D - Overview; Device Introduction; Device Parameters

1. Overview
This manual provides instructions on the usage of the 3D printer, covering aspects such as an overall introduction
to the device, operational procedures, maintenance, and care. The aim of this manual is to assist you in correctly using
and maintaining the 3D printer, ensuring device performance and safety, extending the lifespan of the equipment,
and enhancing print quality. We hope that you follow the requirements and recommendations outlined in this manual
during usage, and maintain attention to and care for the equipment. Thank you for choosing our product, and we wish
you a pleasant experience!
2. Device Introduction
Device Parameters
Basic Parameters
Product Model
MD-600D | MD-1000D
Machine Dimensions
1300*965*1255mm | 1680*1365*1665 mm
Max. Build Dimensions
600*600*600mm | 1000*1000*1000mm
Print Technology
Fused Deposition Modeling (FDM)
Rated Voltage
100-240V, 50/60Hz
Rated Power
2000W | 2700W
Ambient temperature
10℃-30℃ / 50°F-86°F
Extruder Type
Dual Extruders
Max. Nozzle Temperature
350℃
Max. Bed Temperature
110℃
Screen
10inch touch screen
Printing Method
USB Flash Disk / LAN Printing
Connection
USB Flash Disk / WIFI / Ethernet
Power Loss Recovery
Yes
Filament Detection
Yes
Fast Auto leveling
Yes
Camera
Yes
Fast Calibrate Offset
Yes
Supported Filament
Common filament: PLA, PETG;
Engineering filament: PA-CF/GF, PET-CF/GF, HtPA-CF/GF,
PA-GF25/CF25;
Support filament: S-Mulit, S-HtPA, PVA, etc
2