24
Double extrusion: Start the Prime tower
Because there is always one printer in standby mode during the printing process, it is easy to
cause defects such as wire drawing and material leakage. Prime tower can solve this problem,
the extruder will print a prime tower before each layer printing. Any material leakage will be
printed on the tower, effectively avoiding the phenomenon of material leakage when replacing
the extruder.
If you want to print the following two modes, we recommend adding this option to your Gcode.
2
3
Note: The printing position of the Prime tower cannot coincide with the model
1. Select the "Global" section.
2. Select the "Others" section.
3. Check the "Enable" option in the "Prime tower" settings.
1
To Next Page
Loading...
