Minimizer 101363 - Component Cover and Switch Removal; Seat Frame Covers and Switches

14
Covers Seat Frame IPS-Valve, switches for heating, swivel and air-conditioning
covers, lever side (5):
- Remove seat cushion.
- Adjust suspension to highest position and secure it with block between lower
suspension axle and front frame.
- Press nose of shoulder adjustment lever (21) till nose of handle disengages.
- Pull off handle (21) downwards.
- Unscrew screw (1 front screw) and (2) number 2 top screws.
- Undo two plastic rivets (3).
- Fold backrest completely forwards and remove one screw (4).
- Remove cover (5) from seat frame.
Switch for seat lowering:
- Remove screws (7).
IPS valve (12):
- Lift up locking tab (8) safely and Remove air pipe (9) from “Y” connector (10).
- Disconnect three hoses from valve unit.
- Undo retainers of valve and push out valve from cover (5).
Cover, opposite lever side (2):
- Remove cover (20) in general sense of cover.
Operating unit air-conditioning:
- Unhook switch (22) from side cover (5) and unplug connector (23).
Wire diagrams with color codes are found on Pages 42-46 for your convenience.