8
Seats using Universal Riser:
- Disconnect air supply lines and electrical connections.
- Remove old seat from Truck and keep floor bolts.
- Position New Universal Riser so holes in riser line up with the holes in floor. Use original
floor bolts to secure riser to floor.
- Remove 4 bolts at bottom corners of suspension.
- Attach angle brackets to front and rear of suspension with bolts included with riser
Position on top of riser by lining up bracket holes with weld nuts on riser and install 4 bolts
(Torque to 20 NM +/ - 5NM)
To Next Page
Loading...
