Minolta DI2510 - Administrator Settings Management

6.3 Administrator Settings
6
Di2010/Di2510/Di3010/Di3510 6-7
Administrator Management Operations Chapter 6
6.3 Administrator Settings
Changing the administrator access code
This explains the method to specify or change the administrator access code.
To set the administrator access code
1 Follow the procedure described in “To display the Administrator Management
screens” on page 6-2 to display the Administrator Management screen.
2 Touch [Admin. 1], and then touch [Admin. Set].
3 Touch [Administrator Code Input].
4 Use the 10-Key Pad to type in the
administrator access code, and
then touch [Enter].
❍ To change an entered value,
touch [←] and [→] to move the
cursor to the desired position,
and then type in the new value.
❍ To erase the value at the
cursor’s position, touch
[Delete].
❍ Press the [C] key to erase all
entered text.
❍ To return to the previous screen, touch [Cancel].
5 Continue touching [Enter] to return to the Utility screen, and then touch [Exit] to
return to the Basics screen.