5.4 Registering an Image Stamp
5
Di2010/Di2510/Di3010/Di3510 5-31
Utility Mode Operations Chapter 5
5.4 Registering an Image Stamp
Before the Auxiliary function “Image Stamping” can be used, an image must be reg-
istered.
A maximum of five images can be registered. For details on using the “Image
Stamping” function, refer to ““Image Stamping” Function” on page 4-20.
✎
Note
The optional hard disk must be installed.
To register an image stamp
1 Press the [Utility] key.
2 Touch [User Set].
3 Touch [Image Mem. Input].
To Next Page
Loading...
