5
5.4 Registering an Image Stamp
5-32 Di2010/Di2510/Di3010/Di3510
Utility Mode Operations Chapter 5
4 Touch [Input], and then touch
desired registration key.
❍ To erase a stored image, touch
[Delete], and then touch the
number from where you wish
to delete the image.
❍ To check a stored image,
touch [Check], and then touch
the number where the image
that you wish to check is
stored.
5 Select the size of the image
document.
Touch [Enter].
To continue scanning a standard-
sized image document, skip to
step 9.
❍ To scan a non-standard-sized
image document, touch
[Custom Size].
6 Touch .
Then, touch and to
select the length of side X for the
image document (between 1 inch
and 17 inch).
❍ Touch until the cursor
moves below the fraction that
you wish to change.
7 Touch .
Then, touch and to
select the length of side Y for the
image document (between 1 inch and 11-11/16 inch).
❍ Touch until the cursor moves below the fraction that you wish to
change.
8 Touch [Enter].
To Next Page
Loading...
