5.3 Changing Default Settings
5
Di2010/Di2510/Di3010/Di3510 5-7
Utility Mode Operations Chapter 5
5.3 Changing Default Settings
The procedures for changing each of the User’s Choice settings are described be-
low.
To set the “Memory Recall” function
This function is used to specify whether or not the last image copied can be recalled
and printed again.
1 Press the [Utility] key.
2 Touch [User’s Choice].
3 Touch [1/6], and then touch
[Memory Recall].
4 Touch [ON] or [OFF], and then
touch [Enter].
❍ If [ON] is selected, the
previously copied image data
can be printed again, even
after copying has finished or
while the copier is in stand-by.
5 Touch [END] to return to the Utility screen, and then touch [Exit] to return to the
Basics screen.
To Next Page
Loading...
