5.6 Using Copy Programs
5
Di2010/Di2510/Di3010/Di3510 5-35
Utility Mode Operations Chapter 5
5.6 Using Copy Programs
Up to 10 sets of copy settings can be stored as copy programs.
To store a copy program
1 Press the [Mode Check] key.
2 Touch [Job Mem Input], and then
touch the number where you wish
to store the copy program.
❍ Number buttons on which
does not appear have already
been assigned a copy
program.
If a button that has already
been programmed is selected,
the previously assigned copy
program is deleted.
3 Touch [Check], and then touch a number button.
4 Check the programmed settings.
❍ To display screen 2/2, touch
[Next]. To return to screen 1/2,
touch [Back].
5 Touch [Enter] to return to the Mode Check screen, and then touch [Exit] to return
to the Basics screen.
To Next Page
Loading...
