Minolta DI2510 - To Set the Crease;Center Staple Function (Only When the Finisher or Saddle Kit Are Installed)

5.3 Changing Default Settings
5
Di2010/Di2510/Di3010/Di3510 5-29
Utility Mode Operations Chapter 5
To set the “Crease/Center Staple” function (Only when the finisher or saddle
kit are installed)
When the optional saddle kit (including the finisher) is installed, this controls the
offset for creases created using the booklet creation mode, and for any specified
center staples.
1 Press the [Utility] key.
2 Touch [User’s Choice].
3 Touch [5/6], and then touch
[Crease/Center Staple].
4 Touch and to adjust the
setting, and then touch [Enter].
5 Touch [END] to return to the Utility screen, and then touch [Exit] to return to the
Basics screen.