201200
Additional
Power: Two CR123A lithium batteries
Battery Performance:
24 Exposure Rolls 36 Exposure Rolls
Flash Use (%) 20 °C –20 °C 20 °C –20 °C
0 45 rolls 13 rolls 30 rolls 9 rolls
50 21 rolls 6 rolls 14 rolls 4 rolls
100 13 rolls 4 rolls 9 rolls 2 rolls
Test Conditions : Lens (24-85 f/3.5-4.5) is focused from infinity to 2m
three times and the shutter-release button held
partway down for ten seconds before each exposure.
• Battery performance will vary with usage conditions.
• Exposures taken at a rate of 3 rolls/month for 24
exposure rolls, 2 rolls/month for 36 exposure rolls
(starting with fresh batteries).
Dimensions (WxHxD): 143.5 x 97.5 x 65.5mm (WxHxD)
Weight : 575g (w/o camera battery)
Specifications are based on the latest information available at the time
of printing and are subject to change without notice.
SPECIFICATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment. This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
This mark on the bottom of your camera is there to inform
you that this camera meets the requirements of the EU
(European Union) concerning interference causing
equipment regulations. CE stands for Conformité
Européenne (European Conformity).
APPENDIX