135134
MEMORY
Storing New Settings In Memory
When first purchased, standard settings are stored in memory 1, 2,
and 3. This section shows you how to store new settings into mem-
ory.
• It is not necessary to use all three memory settings.
• The stored memory settings are not affected by turning the cam-
era off or by removing the batteries.
1. Set the camera with all the
function settings you want to
store. See page 133.
• Full-auto settings can not be
stored.
2. Open the control-panel door
and press the enter button.
• While pressing the enter
button, the display shows
only the settings to be
stored.
• This display will appear
when your finger is removed
from the enter button.
Full-auto
Your camera is capable of storing three different sets of camera
function settings. This feature is convenient when you will be
repeating the same shooting conditions and want to use the same
settings each time.
Memory 1
Memory 2
Memory 3
• Beautifully defocused images can be produced using the STF
(Smooth Trans Focus) mode, which can be used instead of mem-
ory 3 . See page 180.
When positions 1, 2, 3, or full-auto are select-
ed, the settings of the controls do not neces-
sarily correspond to the actual camera set-
tings. The upper part of the display turns black
to let you know.
P mode
A mode
S mode
M mode
STORING MEMORY
MEMORY
To Next Page
Loading...
Need help?
General
