159158
CUSTOM 1, 2, 3
Custom 1 - AF/Release Priority
• Custom 1 will be stored in memory if you use
the memory function.
• When full auto is selected, focus is always
AF priority, even if Custom 1-2 is selected.
1. AF priority
Shutter will not release unless or appears in the viewfinder.
2. Release priority
Shutter releases even if the focus cannot be confirmed.
Use release priority when photographing moving subjects.
• RP will appear in the display.
Custom 2 - Film Rewind Start
1. Automatic
Film is automatically rewound at the end of the
roll.
2. Manual
User must press the manual-rewind button
to initiate rewind.
1. Film is completely rewound into
the cartridge.
2. Leader left out after rewind.
Camera setup for select-frame film
transport.
Custom 3 - Film Tip
Select-Frame Film Transport (When partially-exposed
film is reloaded)
This custom function allows you to reload a
partially exposed roll of film and wind to a
desired specified frame.
• Convenient when you want to switch to a differ-
ent type of film, and the film presently in the
camera is only partially exposed.
• The camera cannot detect the beginning of an
unexposed frame, so you must remember.
• To avoid overlapping exposures, select 2
frames past the last previously exposed frame.
To set custom functions;
1.Open control-panel door and press the CUSTOM button.
2.Turn the front control dial to select the desired custom function.
3.Turn the rear control dial to seclect the setting.
4.Press the shutter-release button partway down to enter the setings.
Refer to pages 154-157 for additional information.
CUSTOM FUNCTIONS
To Next Page
Loading...
