165164
CUSTOM 4, 5, 6
Custom 4 - DX Memory
1. DX Memory Off
Film speed is always set to the DX-coded
ISO. Non-DX-coded film is set to the previous
roll’s ISO.
2. DX Memory On
Changes to the film speed for a DX-coded roll
are saved and applied to future rolls with the
same DX coded ISO. Use to consistently
over/under-expose a specific film type.
Custom 5 - Release Lock (Film)
1. Release Lock Off
Shutter can be released even if there is no
film in the camera.
2. Release Lock On
Shutter cannot be released unless film is
loaded.
• If the shutter-release button is pressed when
film is not loaded, 0 blinks in the viewfinder and
this message appears in the display.
• While the back cover is open, the shutter can
be released.
Custom 6- Focus-Hold Button (Lens)
1. Focus Hold
Pressing the focus-hold button on the lens
locks the focus.
2. Continuous Bracketing
Continuous bracketing is set if the focus
hold button is pressed while taking the pic-
ture.
• Increment and size of bracketing will be the
same as that set in exposure bracketing
mode (p. 92).
• Flash does not fire.
• If the self-timer or multiple exposure mode is
selected, continuous drive will not work.
3. Depth-of-Field Preview
You can confirm the depth-of-field while
pressing the focus hold button.
• If not using a D lens, you must press both
the focus-hold button and the shutter-release
button partway down to confirm the depth-of-
field.
Focus-hold button
To set custom functions;
1.Open control-panel door and press the CUSTOM button.
2.Turn the front control dial to select the desired custom function.
3.Turn the rear control dial to seclect the setting.
4.Press the shutter-release button partway down to enter the setings.
Refer to pages 154-157 for additional information.
This custom function changes the operation of the focus hold button
on the lens. (The mounted lens must have a focus hold button).
• Film must be loaded before the ISO can be changed.
• Once you load a roll with a different ISO number, the saved ISO will
be cancelled.
CUSTOM FUNCTIONS