151150
DATA RECALL
Using the Focus-Area Selector and Spot-AF Button
When appears, it is
possible to use the focus-
area selector and the spot-
AF button to select the film
areas and data number.
• If the wide/local focus-area
switch is at the locked
position, the focus-area
selector does not work.
Pressing in the directions indicated:
• Moves to the areas as follows:
OFF ON Area 1 Area 2 • • •
Area 7 OFF
OFF Area 7 Area 6 • • • Area 1
ON OFF
• If you press the center spot-AF button,
when “READ” appears, data can be
recalled. This is the same as pressing the
ADJ button.
For the single frame display;
• Frame number will increase.
• Frame number will decrease.
For 4-frame display;
• Display changes one-by-one.
• Display changes every 4-frames.
• The display returns to the data selection
display.
DELETING STORED DATA
1. Open the control panel door
and simultaneously press the
DATA and ADJ buttons.
The data in all of the film areas will be deleted. Film areas cannot
be cleared individually.
• This display will appear.
2. Press the DATA button again.
• This display appears
while all the data is
bieng deleted.
• Do not operate the camera while data is being deleted.
• The display returns to the standard display after the data in the film
area has been cleared.
Focus-area
selector
DATA MEMORY
To Next Page
Loading...
Need help?
General
