5
When an Indicator Lights Up
5-18 EP1085
7 The copier automatically starts the
charging cycle for approximately 5
minutes.
è During this cycle, do not open
the Front Door.
During this cycle, six segments of
theonesdigitLEDonthe
Magnification Ratio Indicator
forming a “0” light up and go out one
after another, indicating that the
copier is being charged with starter.
When the copier has been
completely chargedwith Starter, the
indication on the Magnification
Ratio Indicator changes to “100”
and the cycle stops.
8 If “E1” or “E2” is indicated on the
Magnification Ratio Indicator, the
tape has not beenremovedfromthe
StarterBottle.Swingdownthe Front
Door and remove the tape and
perform the starter charging
procedure again.
If “E1” or “E2” is indicated again call
your Technical Representative.
9 Swing down the Front Door, swing
out the Bottle Holder and remove
the Starter Bottle.
10Tap the new Toner Bottle on a hard
surface, such as a desk, several
times. Then, turn the Toner Bottle
over and tap it several times again
in the same manner.
To Next Page
Loading...
