Minuteman E24 - Page 37

10. Table of Error Codes
Error code Error source Remarks
Check connecting cable between central
4.5.2.5. Control panel not recognized controller and control panel. This error
occurs upon switching on only.
4.5.3.5. No response control panel (Timeout)
Check connecting cable between central
controller and control panel. This error
it hi l
occurs upon sw
it
c
hi
ng on on
l
y.
4.6.1.2. Internal controller error
If error is permanent and even after
repeated switching on and off of the
machine, replace central controller
5.1.4.1. Main contactor does not switch
Does main contactor K1 switch? Check
main contactor wiring. Contacts
461
Error upon system start (signal
If error is permanent and even after
dihi dfffh
5.
4
.
6
.
1
.
Error
upon
system
start
(signal
states)
repeate
d
sw
i
tc
hi
ng on an
d
o
ff
o
f
t
h
e
machine, replace central controller
"H"
"P"
Hand brake unlocked
Hand brake locked
See chapter 7.1
Magnet brake at drive motor
37