27
Note! Before turning on the water
supplies refer to section:
'Commissioning and Control
Assembly Installation'.
3.15 Turn on the water supplies and check
for any leaks.
3.16 Refit the building-in shroud removed
earlier. Secure the shroud in position
with the screws.
3.17 Plaster and tile as necessary up to the
sides of the building-in shroud. Make
sure that the finished tiled wall surface
is within the area as shown on the
building in shroud.
3.18 When the plaster/tiles have set,
remove the screws and pull the entire
building-in shroud away.
Retain the screws for later use.
Tiling Area
Alternative
Rear Fixing
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
To Next Page
Loading...
