40
Front Panel Menu Operation
At this point the display varies, depending on your choice:
• If you selected “yes”, the display shows either the message “Pos. Alm. Sequence
Bypassed” or “Pos. Alm. Sequence Unbypassed”, then it returns to the Command Menu.
• If you selected “no”, the display shows the message “Operation cancelled”, then it
returns to the Command Menu.
5.2.11 Buzzer
This option is useful if you want to bypass or un-bypass all buzzers in the system.
At this point the display varies, depending on your choice:
• If you selected “yes”, the display shows either the message “Buzzer bypassed” or
“Buzzer unbypassed”, then it returns to the Command Menu.
• If you selected “no”, the display shows the message “Operation cancelled”, then it
returns to the Command Menu.
Step 2: Bypass the positive alarm sequence
The system asks whether or not you want to bypass or
unbypass the positive alarm sequence.
1. Use and to select “yes” or “no”.
2. Press to continue.
Step 1: Select Buzzer Bypass
1. Use and to scroll to “Buzzer”.
2. Press to continue.
Step 2: Bypass the buzzer
The system asks whether or not you want to bypass or
unbypass the buzzer.
1. Use and to select “yes” or “no”.
2. Press to continue.
Step 3: Select timeout
1. Use and to select the duration of the
bypass. The duration can be between 1 and 8 hours
and the default is 6 hours.
2. Press to continue.
Pos. Alm. Sequence
Unbypassed.
Bypass?Y
- Bypass Menu -
7 Node Outputs
8 Pos. Alm. Seq
9 Buzzer
Buzzer unbypassed
Bypass?Y
- Buzzer Bypass -
Timeout (hr) 6
To Next Page
Loading...
Need help?
General