Front Panel Menu Operation
15
• Press CANCEL ( ) to exit to the Reports Menu.
If a printer is connected to the panel, follow step two, below.
Current Levels
This option reports on the current levels of addressable devices.
At this point the display will vary, depending on whether or not you have a printer connected.
• If a printer is not connected to the panel, skip to step three.
• If a printer is connected to the panel, follow steps two and three, below.
If you print the Current Levels to the screen,
• Use and to scroll the cursor through the log.
Step 2: Print the Event Log
•To print the Alarm Log to the printer, press ENTER
( ) when the cursor flashes beside “Printer”.
•To print the Alarm Log to the screen, press then
ENTER ( ) to select “Screen”. Follow the
instructions above to navigate the Event Log.
Step 1: Select Current Levels
1. Use and to scroll the cursor to “Current
Levels”.
2. Press ENTER ( ) to select the Current Levels
submenu.
Step 2: Print the Current Levels
•To print the Current Levels report to the printer, press
ENTER ( ) when the cursor flashes beside
“Printer”.
•To print the Current Levels report to the screen, press
then ENTER ( ) to select “Screen”. Follow
the instructions above to navigate the Current Levels.
Step 3: Select loop number
•Select a loop number by using and to
scroll through the numbers, or
•Select all loop numbers by pressing ENTER ( ).
Wait five seconds. Use and to scroll the
cursor through the loops.
- Report to -
1 Printer
2 Screen
- Reports
Menu -
1 Alarm Log
2 Event Log
^
- Report to -
1 Printer
2 Screen
-Select Loop
Number -
Loop: A
L L
To Next Page
Loading...
Need help?
General
