Front Panel Menu Operation
21
Unbypassing an active loop
When you unbypass a loop that went into alarm while it was bypassed, you will see the following
message:
If you select “yes” to unbypass this loop, the system will immediately go into alarm. To avoid this
problem, press the System Reset button before unbypassing the loop.
Relay Disconnect
This option is useful if you want to disconnect or reconnect the aux relays.
At this point the display will vary, depending on your choice:
• If you selected “yes”, the display will either show the message “Relays disconnected” or
“Relays reconnected”, then it will return to the Command Menu.
• If you selected “no”, the display will show the message “Operation cancelled”, then it will
return to the Command Menu.
Step 1: Select Relay Disconnect
1. Use and to scroll the cursor to “Relay
Disc”.
2. Press ENTER ( ) to continue.
Step 2: Select “yes” or “no”
1. The systems now asks you whether or not you would
like to bypass the aux relays. Use and to
select “yes” or “no”.
2. Press ENTER ( ) to continue.
Warning: This
loop is active. Do
you really want
to unbypass it?
- Bypass Menu
-
1 Device /
Circuit
Common aux
relays
currently
connected
To Next Page
Loading...
Need help?
General
