Installation
TX3 Touch Screen Installation Manual 33
2. Using the surface mount enclosure as a template, mark the back mounting
hole locations of the two keyholes as shown in Figure 14. Ensure that at
least one side is over a wall stud.
Figure 14. Surface mounting the enclosure
3. Remove the enclosure and place the top two fasteners halfway into the
marked hole locations and wall stud.
4. Place the enclosure onto the two fasteners and lower it so that the fasteners
fit in the narrow part of the keyholes.
5. Screw the other four fasteners into the four remaining holes.
6. Tighten all six fasteners into place.
7. Close the door until it clips into place.
8. Proceed with the power supply installation described in section 2.11 on
page 67.
Keyhole Keyhole
screw
screw
screw
screw
To Next Page
Loading...
