Mircom TX3-TOUCH-F15-B - Figure 49 Reinforcement Bracket with Bolts; Figure 50 Reinforcement Bracket with Nuts

62 TX3 Touch Screen Installation Manual
Installation
To install the Touch Screen Kiosk base plate
1. Find a suitable location for the Kiosk next to the building entrance and
above the building electrical and communications conduit.
2. Remove the door from the Kiosk.
3. Remove the 4 bolts from the reinforcement bracket, as shown in
Figure 49.
Figure 49. Reinforcement bracket with bolts
4. Remove the 6 nuts on the reinforcement bracket, as show in Figure 50, and
then remove the bracket.
Figure 50. Reinforcement bracket with nuts